Traditional flashing won’t work? Try this molded sealant pocket!

By Dani Sheehan. 

Save time, money and headaches with this two-piece flashing solution designed for any roofing system. 

When it comes to roof flashings and accessories, FlashCo is the trusted source among contractors, distributors and manufacturers. Providing dependable prefabricated accessories for over 20 years, their products save contractors time and energy by providing innovative solutions. One such product is the FlashAccessory™ Molded Sealant Pocket. A reservoir for embedding irregular penetrations and conduit bundles in one-part sealant, it allows for easy installation and guaranteed protection. 

Sealant pockets are required for areas with multiple projections, particularly when those projections are too small for a boot or field wrap, or in cases when traditional flashing won’t work. FlashCo makes it easy to find the solution for these tricky jobs thanks to FlashAccessory™ Molded Sealant Pocket.  

The two-piece design allows for fast and easy installation – you no longer need to worry about disconnecting conduits or lines before installing. And with the two-inch vertical wall, it creates a perimeter around the penetration for superior waterproofing while the reinforced TPO flange ties into the existing field membrane. With six cutting guide points, you can adjust the size right on the roof! 

You never know when you’re going to need an alternative to traditional flashing methods on the job! Stock up on these flashing accessories and save time and labor on your next tricky project.